Z-wave is a radio protocol widely used in smart home devices. Devices in the Z-wave protocol all work within the same rules and these rules are built to fit the smart home industry. If you wish to know more about Z-wave, please go to this article.
To add new Z-Wave devices to the Z-Wave Network or remove existing devices through the Animus Heart GUI, follow the steps shown in this article.
Please note: If the Heart is included into another Z-Wave network (see /wiki/spaces/AHK/pages/231505942), then it's possible that it is not the primary controller of the network. In this case it is only possible to add/remove new Z-Wave devices through the terminal.
To be able to add/remove Z-Wave devices through the terminal enter command group zwave in the Web Terminal.
To start the process of adding a Z-Wave product, type
add start |
To start the process of removing a Z-Wave product, type
remove start |
The process of replacing a failed Z-Wave product with another (non-included) device is the same as adding a new Z-Wave device (through the console), except that the first step is:
add start <failed node to replace> |
The process of removing a failed Z-Wave product is the same as removing a Z-Wave device (through the console), except that the first step is:
remove start <failed node to remove> |