Z-Wave is a wireless communications protocol used primarily for home automation. Read more about the technology here.
...
- Find which parameter you wish to change and what its the corresponding ID is. For example you might wish to adjust ramp rate of a device.
Note that some parameters are found by your Animus Heart automatically, which you can change the values on. If you wish to add a completely new parameter, please use the 'New parameter' input area. - Set the size of how many bytes this parameter can have. It might be tempting to just choose the first option you bump into and move on with it, but a wrong Data Size won’t work at all and in some cases it can prevent the device itself from working properly.
Unless stated otherwise, all parameters are 1 byte. However, there are some devices that require other data sizes and for that, it’s extremely important to carefully read the manual for the device before doing any changes. - Enter the new value for your setting.
- Save. Animus Home will attempt to configure the node after you click the Save button, and if successful, you will get a notification saying the save was successful.
...
| Info | ||
|---|---|---|
| ||
If the thing you expect to happen is not happening and the device is battery driven, then it might be in sleep mode. When the device is in sleep mode it cannot perform any configuration. Awaken the device by following the steps in device documentation for wake up (usually a device is woken up by clicking its pairing button and redo the steps above). |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
| To reset the parameters for the device, Aeotec Multisensor Gen5, go to: Device -> Edit -> New Parameter Add the following parameter:
|
...