You can enter recovery mode to make a factory reset or to update the firmware of your Animus Heart.
These are the different LIGTHS during the boot stage
(a) Light blue → (b) Dark blue → (c) Orange → (d) Light blue → (e) Dark blue or Orange
In stage (e) the LED-light shows if it booted the regular system or the recovery system. To enter recovery system you need to have the Orange color at stage (e)
Step-by-step guide
Warning |
---|
Read all the steps first before attempting anything! |
...
These are the
...
steps to enter "recovery mode":
- Unplug the power cable and plug it back again to start the different boot-stages.
- Wait until the boot stage reaches (c), Orange LED-light, and unplug at this stage.
- Plug the power back in and wait until the Halo shows final Orange as in stage (e). If you get the default blue light is shown after a minute your Heart is not in recovery mode, please redo the steps 1-Dark blue in stage (e) then you didn't unplug at the correct time in step 2.
- Open a web browser and enter the IP of your Heart (if you don't know the IP, visit the Find IP page).
NOTE: Animus Heart needs to be connected to the network through the Ethernet cable. - If you have succeeded then you should have a view like this:
- To get out of recovery mode simply reboot your Heart, either by clicking the reboot button on the GUI or unplugging and plugging back in your Animus Heart.
...